路由器综合路由配置 配置三层交换机 www.zhishiwu.com Switch>enableSwitch#conf tEnter configuration commands, one per line. End with CNTL/Z.Switch(config)#vlan 2Switch(config-vlan)#exitSwitch(config)#interface fastEthernet 0/2Switch(config-if)#switchport access vlan 2Switch(config-if)#no shutdownSwitch(config-if)#exitSwitch(config)#interface vlan 1 Switch(config-if)#ip address 192.168.1.1 255.255.255.0Switch(config-if)#no shutdown Switch(config-if)#exitSwitch(config)#interface vlan 2 %LINK-5-CHANGED: Interface Vlan2, changed state to upSwitch(config-if)#ip address 192.168.2.1 255.255.255.0Switch(config-if)#no shutdownSwitch(config-if)#end Switch#show ip routeSwitch#enableSwitch#configure terminalEnter configuration commands, one per line. End with CNTL/Z.Switch(config)#router ripSwitch(config-router)#network 192.168.1.0Switch(config-router)#network 192.168.2.0Switch(config-router)#version 2 配置R1 www.zhishiwu.com Router>enableRouter#configure terminalEnter configuration commands, one per line. End with CNTL/Z.Router(config)#interface fastEthernet 0/0Router(config-if)#ip address 192.168.2.2 255.255.255.0Router(config-if)#no shutdown %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up Router(config)#interface fastEthernet 1/0Router(config-if)#ip address 192.168.3.1 255.255.255.0Router(config-if)#no shutdown %LINK-5-CHANGED: Interface FastEthernet1/0, changed state to upRouter(config-if)#exitRouter(config)#router ripRouter(config-router)#network 192.168.2.0Router(config-router)#version 2Router(config-router)#exitRouter(config)#router ospf 1Router(config-router)#network 192.168.3.0 0.0.0.255 area 0 配置R2Router>enableRouter#configure terminalEnter configuration commands, one per line. End with CNTL/Z.Router(config)#interface fastEthernet 0/0Router(config-if)#ip address 192.168.3.2 255.255.255.0Router(config-if)#no shutdown %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up Router(config-if)#exitRouter(config)#interface fastEthernet 1/0Router(config-if)#ip address 192.168.4.1 255.255.255.0Router(config-if)#no shutdown %LINK-5-CHANGED: Interface FastEthernet1/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet1/0, changed state to up Router(config-if)#exitRouter(config)#router ospf 1Router(config-router)#network 192.168.3.0 0.0.0.255 area 0Router(config-router)#network 192.168.4.0 0.0.0.255 area 0
